PRL's FK8 Civic Type-R High Volume Intake system utilizes a 6 cone filter and billet 2-piece MAF housing with velocity stack(s) to allow maximum airflow while delivering proper fuel trims. The HDPE rotomolded air box utilizes the factory air duct and seal for optimal airflow and heatsoak reduction. Custom molded 4-ply silicone allows for all components to be safely attached without obstructing airflow.
(1) 4-Ply Silicone Intake Hose. (1) Evap Flange (Anodized Black). (4) Stainless Steel Breeze Lined Clamps.
All testing was performed on the same day with a rather mild 55 degree Fahrenheit day and moderate humidity. We started all single dyno pulls at 174 degrees, while continuous (back-to-back) dyno pulls start at 174 degrees and end around 197 degrees. For our first comparison we tested the factory intake system on KTuner's stock equivalent ECU map versus our High Volume Intake System on KTuner's stock equivalent ECU map for an apples-to-apples comparison. Run 2 was the coolest (174 degree starting temp) for both setups.We saw an 11 - 12 horsepower peak gain and 32 horsepower gain throughout the mid-range over the factory intake system. Continuous dyno pulls and testing under the same conditions produce identical gains time after time. Even our hottest runs, Run 4 (197 degree starting temp), showed a 5 horsepower peak gain and 26 horsepower gain throughout the mid-range over the factory intake system. The hottest runs, Run 5, showed a 9 horsepower peak gain and 18 horsepower gain throughout the mid-range. One of our main focuses with this intake system was to offer a factory-like fuel trims (much like our 1.5T Cobra CAI & SRI) for optimal drivability and performance. We spent quite a bit of time designing what we determined is the best intake system/MAF housing on the market. Thus far we have seen Short Term Fuel Trims within +2-4% of the factory. We have a few more tricks up our sleeve, but are very happy and confident with what we have currently. Honda: Civic Type R (2017+). When receiving your package, please open all of the boxes immediately to check if all the contents are inside and not damaged. If the product received is defective, a replacement will be sent as soon as possible.
I will refuse any damaged or products that are not in good condition. They will inform you on how to proceed based on their policies.All of my products are 100% brand new unless otherwise stated in the description above. As mentioned above, please inspect your order upon receipt. All items (except those exempted) are intended for off road use only, may never be used on public roads and highways. The item "PRL Motorsports High Volume Air Intake System Kit for Honda Civic Type R FK8 17+" is in sale since Friday, March 13, 2020. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Air Intake & Fuel Delivery\Air Intake Systems".
The seller is "circuitspecr" and is located in Covina, California. This item can be shipped worldwide.